SVG to STLの使い方
- 1
Open your SVG
Drop the file or paste its code. A PNG or JPG logo also works; it is traced into shapes first.
- 2
Set the print size
Type the width in millimetres and choose the thickness; the height is worked out from the logo's proportions.
- 3
Check the model
Rotate the preview to inspect holes and edges, add a layer step for raised parts, or a bevel for big prints.
- 4
Download the STL
Save the binary STL and open it in your slicer; it already lies flat at the right size.
制限と Pro
Free: SVG files up to 25 MB, widths from 5 to 1,000 mm, thicknesses from 0.4 to 20 mm and models up to 3 million triangles; PNG and JPG logos are traced at 1,024 px first.
Pro takes files above 25 MB and removes the ads. Pro を見る
SVG to STL について
STL is the file that slicers such as Cura, PrusaSlicer, Bambu Studio and OrcaSlicer expect, while design apps export logos and icons as SVG. This page bridges the two: it reads the paths in your SVG and extrudes them into closed solids, ready to slice.
Size is set the way you would measure the print. Type the width in millimetres and the thickness, and the height follows the artwork's proportions. An STL stores no unit, so the file is written in millimetres, the unit every common slicer assumes. The model lies flat with the logo facing up and its back at zero height, so it lands on the build plate without any rotating.
Holes are kept: the inside of an O, a B or a ring is cut through, following the SVG's fill rule. Shapes that overlap simply merge when sliced. Stroked lines, common in icon sets, become solid bars as wide as the stroke. If parts of the logo should stand proud, as on a two-height sign or keychain, raise the layer step and each new colour is extruded a little higher while the back stays flat.
A bevel is off by default because small chamfers print poorly; switch it on for larger pieces and it rounds only the top edges. Keep lines at least two nozzle widths wide, about 0.8 mm with a 0.4 mm nozzle, or the slicer may drop them.
The STL holds the shape only. For a coloured model use GLB instead, and convert any SVG text to outlines before you start.
プライバシー
The SVG is parsed and extruded inside this browser tab, and the STL is written there too; nothing about your design is sent to a server. Close the tab and it is gone. Only your settings, such as the width and thickness, stay in this browser for next time.
主な機能
Sized in millimetres
Set the width and thickness; the height follows the artwork and is shown before you download.
Raised layers
Each colour can stand a little higher than the one below it, all on one shared flat back.
Ready for the slicer
A binary STL lying flat, logo up, at zero height, with no rotating or scaling needed.